1
Clean up iron filings and oil stains inside the machine tool
2
Full stroke lubrication of each axis
Turn on the lubrication switch on the panel of the CNC system to check whether the operation status of the lubrication system and the oil supply pressure are normal. If the lubricating fluid is insufficient, add lubricating fluid.
Then run each axis to the maximum stroke, so go back and forth 2~3 times to ensure that each axis is fully lubricated.
3
Clean the workbench and apply anti-rust oil
Clean up the T-slots of the workbench, tooling fixtures and other areas that are prone to residues and debris. Wipe down all exposed surfaces until free of fluid and swarf deposits. The workbench and fixtures are oiled to prevent rust.
4
Clean the spindle and apply anti-rust oil
Clean up the T-slots of the workbench, tooling fixtures and other areas that are prone to residues and debris. Wipe down all exposed surfaces until free of fluid and swarf deposits. The workbench and fixtures are oiled to prevent rust.
5
Cleaning the tool holder (tool magazine)
If it is a machining center, the tool needs to be disassembled from the tool magazine, cleaned and oiled, and stored in the warehouse. Then clean and oil the tool magazine.
6
Clean the filter screens of the machine tool electrical cabinet refrigerators and oil cooler accessories
7
Each axis telescopic cover oil protection
8
The travel of each axis returns to the middle position
9
Cut off the power supply and air supply of the machine tool, and close the protective door and electric cabinet door
